BOARDS - Control (Stepper Motor Driver) Share your driver boards ideas and specs, pricing, ect... Mon, 11 May 2026 18:04:38 +0000 Mon, 11 May 2026 18:04:38 +0000 PhlatForum http://www.phlatforum.com/xenforo/forums/boards-control-stepper-motor-driver/ CW 230 and CW 8060 micro stepping motor drivers mislabel. Thu, 28 Mar 2013 13:06:16 +0000 http://www.phlatforum.com/xenforo/threads/cw-230-and-cw-8060-micro-stepping-motor-drivers-mislabel.3084/ http://www.phlatforum.com/xenforo/threads/cw-230-and-cw-8060-micro-stepping-motor-drivers-mislabel.3084/ invalid@example.com (thunder hawk) thunder hawk mislabeled CP and CW pin outs printed on top. CW+ and CW- should be CP+ and CP-.
If you are wiring up these stepper drivers to a USB-CNC controller, and your motors will
not work, swap the CP & CW wires. See picture below.


It took me two days of trying all kinds of things to get the motors to step.
I could not get my stepper drivers to work at all :banghead: until I put the USB-CNC
board on my scope...

CW 230 and CW 8060 micro stepping motor drivers mislabel.]]> 3