Hey guys, just finished a profile Jet as mentioned above!! This has always been one of my favs even though it was only a prototype and never went into production, it was from the same era as the Mig -15 !! It has really nice curves and I am trying it with a flat horizontal stab/elevator instead of the 15 degree taper to try and stabilize this bird!! Hope you guys like it , I plan to maiden this as soon as the rain lets up!! Also I ran this with a puller because of the instability a pusher would have and placement would be tricky because of prop clearance !!!

spec are
wingspan 34"
Length 33" from prop to tail
AUW under 7oz
Motor 24gram BW 1500kv
3 cell 610 Rhino Lipo
9gram servos

Thanks
John Attached files TA-183 Focke Wulf Huckbein.cnc (34.2 KB)Â TA-183 Huckbein.skp (464.6 KB)Â

 

Hey guys, if you have any interest in building one of these email/PM me for a complete PDF file of my build instruction, reserved for customers and Friends

Thanks
John

 

How would I change that bit to an 1/8 bit to cut with?

 

Hi Frank, unfortunately you would have to open the SKP file and erase all the phlat edges and change the parameter box to .125 bit and re apply new phlat edges, Its not a big deal because there are only a few parts!! Hope this helps!!!

John

 

Ah ok thank you sir. I will make the changes. Plane looks like a fun flyer. Excuse me while I get some foam set up.....

 

Hi Frank, I just reworked the file for you with an 1/8" bit!! Hope this helps! !!

John Attached files TA-183 Huckbein large bit.cnc (30.7 KB)Â TA-183 Huckbein.skp (781.6 KB)Â

 

wow thank you John. I was finishng up an original and was checking in here again in between gluing and see you have the updated one. Yours is next on the assembly line for sure