1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

How much room

Discussion in 'Troubleshooting and Build Support' started by topflight36, Nov 18, 2010.

  1. topflight36

    topflight36 Member

    Offline
    Messages:
    32
    Trophy Points:
    6
    I am working on re arranging my shop for the arrival of the MK. I was wondering how much room will I need infront and behind the unit aproximately.

    Thanks
    Tom
     
    topflight36, Nov 18, 2010
    #1
  2. Evil-Tunes

    Evil-Tunes Moderator Staff Member

    Offline
    Messages:
    659
    Trophy Points:
    16
    Location:
    Southern N.J.
    The foam runs through the Machine so. Prob. about 2 feet more than the foam you want to cut. I have mine on wheels so I can pull it off the wall to cut then back after. Then I can use the floor space in front for other things.


    Cheers
    E-T
     
    Evil-Tunes, Nov 18, 2010
    #2
  3. theothers

    theothers Administrator Staff Member

    Offline
    Messages:
    761
    Trophy Points:
    18
    Location:
    New Jersey
    topflight36, you may want to consider setting up your Phlatprinter 3 in a corner. This allows you to have space behind the Phlatprinter for the material to move freely.
     
    theothers, Nov 20, 2010
    #3
  4. Kroko

    Kroko Member

    Offline
    Messages:
    106
    Trophy Points:
    16
    Hi

    What are dimensions of Phlatprinter 3? I want to make table/stand with sheels and I wondering what dimensions I need for tabletop.

    andrej
     
    Kroko, Dec 17, 2010
    #4
  5. Kroko

    Kroko Member

    Offline
    Messages:
    106
    Trophy Points:
    16
    Can somebody measure width and depth of Phlatprinter3 please.
     
    Kroko, Dec 18, 2010
    #5
  6. kyyu

    kyyu Active Member

    Offline
    Messages:
    1,183
    Trophy Points:
    36
    Location:
    Maryland
    There are measurements posted here, when I asked the same question: viewtopic.php?f=267&t=2344#p24065

    And I copied this down from the chat, posted by Mark:
    -Kwok
     
    kyyu, Dec 18, 2010
    #6
  7. kram242

    kram242 Administrator Staff Member

    Offline
    Messages:
    6,311
    Trophy Points:
    13
    Location:
    NJ
    Sorry guys just ran into this post :)
    Thanks Kwok for getting that info, I think we need to add it to a specs section.
    Mark and Trish
     
    kram242, Dec 19, 2010
    #7

Share This Page