1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

Wheel Pants

Discussion in '* Scratch Built Section *' started by Flashsolutions, Feb 3, 2009.

  1. Flashsolutions

    Flashsolutions Active Member

    Offline
    Messages:
    1,123
    Trophy Points:
    38
    Location:
    Leesburg, Florida
    Here is some wheel pants I made for my new Arrow Bipe made from 6mm Depron. SU file attached.

    Glue the two inside pieces together and then add the outside pieces. Round the edges with sandpaper and hot glue to plane.

    This set was made for 1 1/2" wheels. Scale the SU file as needed for whatever size you require. Attached files [​IMG] wheelpants.skp (275.5 KB)Â
     
    Flashsolutions, Feb 3, 2009
    #1
  2. 3DMON

    3DMON Moderator Staff Member

    Offline
    Messages:
    2,380
    Trophy Points:
    38
    Location:
    Sebastian, Florida
    Good idea.
    They look good on there.
     
    3DMON, Feb 3, 2009
    #2
  3. kram242

    kram242 Administrator Staff Member

    Offline
    Messages:
    6,311
    Trophy Points:
    13
    Location:
    NJ
    Thanks Flash!
     
    kram242, Feb 8, 2009
    #3

Share This Page