1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

2 steppers on X axis

Discussion in 'Easy CNC Driver Card' started by KX-5, Jan 4, 2013.

  1. KX-5

    KX-5 Member

    Offline
    Messages:
    241
    Trophy Points:
    18
    Location:
    Urbandale, IA
    My new OpenRail CNC machine will use 2 steppers to drive the X Axis. I have an Easy CNC driver board where one of the driver circuits went bad and replaced the card with a new one. My question is, can I use one of the drivers on my extra board as the driver for the second X stepper? And, if so, how would it be connected? Thanks.
     
    KX-5, Jan 4, 2013
    #1
  2. KX-5

    KX-5 Member

    Offline
    Messages:
    241
    Trophy Points:
    18
    Location:
    Urbandale, IA
    KX-5, Jan 4, 2013
    #2
  3. kram242

    kram242 Administrator Staff Member

    Offline
    Messages:
    6,311
    Trophy Points:
    13
    Location:
    NJ
    Nice find LaVerne :good: Im sorry I did not see this post early on, I would have helped to find an answer :oops:
    Thanks for the update and we look forward to your cnc build! :doubleup:
    Mark and Trish
     
    kram242, Jan 5, 2013
    #3

Share This Page