1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

OO7 JET! (Depron Bede BD-5)

Discussion in 'Single Wing Aircraft Plans' started by Evil-Tunes, Nov 14, 2009.

Page 2 of 2
  1. gravityisnotmyfriend

    gravityisnotmyfriend Member

    Offline
    Messages:
    32
    Trophy Points:
    8

    Any chance you could reload these sketchup files? Looks like the links got lost during the move. I had a BD-5 a couple of years ago, but crashed her pretty hard on the maiden due to an aft CG. It was so tedious to cut out that I never bothered with another one. But, now with the phlatprinter, it'll be cake!
     
    gravityisnotmyfriend, Jul 16, 2013
    #26
  2. gravityisnotmyfriend

    gravityisnotmyfriend Member

    Offline
    Messages:
    32
    Trophy Points:
    8
    Looks like it was actually 3 years ago. Never did get that plane flying right, but the first flight was after heavy repairs. Hopefully, I can do better this time!
     
    gravityisnotmyfriend, Jul 16, 2013
    #27
  3. Evil-Tunes

    Evil-Tunes Moderator Staff Member

    Offline
    Messages:
    659
    Trophy Points:
    16
    Location:
    Southern N.J.
    I think this is them 1/16 bit
     

    Attached Files:

    Evil-Tunes, Jul 20, 2013
    #28
  4. gravityisnotmyfriend

    gravityisnotmyfriend Member

    Offline
    Messages:
    32
    Trophy Points:
    8
    Yup, those are them.

    I'm pretty sure I'm running an 1/8th" bit (I'll check when I get home) so I'll have to regenerate the G-Code. But it'll be far easier than trying to recreate the sketchup file from the .dxf I have.

    Thank you much!
     
    gravityisnotmyfriend, Jul 24, 2013
    #29
Page 2 of 2

Share This Page