1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice

Outside cut problems

Discussion in 'SketchUcam Help' started by john bell, Jun 15, 2017.

  1. john bell

    john bell New Member

    Offline
    Messages:
    24
    Trophy Points:
    1
    Location:
    BC
    I'm cutting out a rectangle with a tapered side. The cut produces a piece smaller then the drawing. 7mm comes out as 5.11mm and so on.
    I thought it might be the calibration so I adjusted it by jogging 100mm and measuring it and changing the settings until its perfect, exactly 100mm movement.
    I'm using a 1/8 bit and have a big ox cnc with tinyg 8 and chillipeppr
    Is there some settings that I might have overlooked?

    Thanks
     
  2. TigerPilot

    TigerPilot Well-Known Member

    Offline
    Messages:
    1,578
    Trophy Points:
    48
    Posting the .skp file may help tons to try to solve your problem.
     
    swarfer likes this.
  3. swarfer

    swarfer Moderator Staff Member

    Offline
    Messages:
    808
    Trophy Points:
    28
    Location:
    Grahamstown, South Africa
    Are you absolutely sure you set the bit size before inserting the cutlines?

    Changing bit size will not move the cutlines for you, you have to remove and replace them to get the correct offset.
     

Share This Page