1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

Miss Hanger one

Discussion in 'Single Wing Aircraft Plans' started by krashlnd, Apr 7, 2009.

  1. krashlnd

    krashlnd New Member

    Offline
    Messages:
    1
    Trophy Points:
    0
    Hey guys,
    I know I am not a Phlatprinter owner but I have a large homebuilt cnc router. I just thought Id post some of my cut files for you guys to try. I used cellfoam 88 starting cut is in the middle of the board. I am not sure how it might work for you guys. But here it is.

    PS Kram, Is it ok to post other cut files and dxf files that I have converted from RCGroups?
    Later Steve Attached files MHO Cut Files.zip (95.9 KB)Â MHO dxf files.zip (38.6 KB)Â
     
    krashlnd, Apr 7, 2009
    #1
  2. Anonymous

    Anonymous New Member

    Offline
    Messages:
    1,280
    Trophy Points:
    0
    Hey krashlnd, the PhlatBoyz were busy at the Toledo Show and probably didn't see your post, so don't take offense at getting no reply from them.

    You may have seen the recent posts titled "LEGAL STUFF - TAKE THE OATH!", which are kinda in the same vein as your question, so I think I can answer you from that context. Sharing your own design is wonderful, but if it's someone else's design you should not post it to share unless you have the original designer's permission. I guess it's up to you to decide if the design is primarily yours or someone else's.

    Personally, I haven't downloaded your posted files yet, but probably will - and I thank you for taking the time to post them, here. :)
     
    Anonymous, Apr 11, 2009
    #2
  3. kram242

    kram242 Administrator Staff Member

    Offline
    Messages:
    6,311
    Trophy Points:
    13
    Location:
    NJ
    As much as I am reading and talking to people about this, If the files are not your own design. It seems that as long as the files are already posted as free files and you are not making money on them
    and your try to credit the original designer then they can be posted just as if they were a dxf or pdf on other forums :D
    Mark
     
    kram242, Apr 14, 2009
    #3

Share This Page