1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice

CNC USB Software Issue

Discussion in 'Planet - CNC USB Software' started by airstik2003, Jul 25, 2011.

  1. airstik2003

    airstik2003 New Member

    Offline
    Messages:
    2
    Trophy Points:
    1
    Hey everyone,
    I have an older Dell with a 2.2 processor, half a gig of ram running on windows 7 32 bit,
    and a Toshiba laptop with a 2.2 dual-core processor, 4 gigs of ram on windows 7 64 bit.
    The laptop runs the software with no problem but the desktop will not import the settings from the installation disk. Can it be that the older computer just is not compatible sense my bran new laptop runs it just fine?

    Thank you very much
    Tom
     
  2. jovian

    jovian Member

    Offline
    Messages:
    208
    Trophy Points:
    16
    Withoout knowing more details its kinda tough to say exactly what the problem is. That said that amount of memory for a windows 7 desktop is really really low. Bumping it to 2 gigs should vastly inncrease its performance with everything. That poor harddrive is probably thrashing madly to run basic things. Bumping the desktop to 4 gigs is even better wont do you any good beyond that though as thats the limit for 32 bit machines.
     

Share This Page