1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

Cutting 1/2 bluecore for the first time.

Discussion in '* Scratch Built Section *' started by frankrcfc, Jun 13, 2010.

  1. frankrcfc

    frankrcfc New Member

    Offline
    Messages:
    381
    Trophy Points:
    0
    Location:
    Battle Creek, Mi
    Just got a piece of 1/2" 4x8' bluecore sheet. Brian and I are making a 51" profile P-51. Printer cut it nicely even though the vid shows a bit of ragged cutting. That was actually the plastic coating. we cut the foam at 25 IPM with an 1/8" bit.
     
    frankrcfc, Jun 13, 2010
    #1
  2. kram242

    kram242 Administrator Staff Member

    Offline
    Messages:
    6,311
    Trophy Points:
    13
    Location:
    NJ
    Nice job boyz! That came out great and its HUGE, I love it :)
    Thanks for the cool video can't wait to see this one in the air.
    Mark and Trish
     
    kram242, Jun 14, 2010
    #2

Share This Page