I am having such a blast with my MKII and now that I am venturing outside of FFF to 3mm Depron, I thought it would be nice if we could list the different cutting bits we have used with good or bad results. I know I have seen some of you post your particular uses but this could be a place for us to enlighten each other. Non of my local Hardware stores or Depots sell the smaller(under 1/8" Carbide style bits).
Please post with a link if possible!!

Thanks
John

 

I like the 1/16 endmill chip breaker, it works well and has a fish tale tip on it.
(see the wood cutting thread I started here: (viewtopic.php?f=126&t=971#p8200) I've always used this bit on foam, works well @ ~40ipm.

 

Awesome TV, I did read that and am amazed at the results you were getting from that bit, well, that and your attention to detail . Do you have a good source for the 1/16" bit or is Ebay a good place to start!!!

Thanks
John

 

I bought mine from a seller w/ user name toolsandtunes. He always sends free samples too.

 

Thank you my Friend I will look him up!!

Mark and Trish may be offering some bits as well in the Phlat Store! This will take the guess work out for all of us


John

 

oops I corrected sellers name.