1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice

First cut ...

Discussion in 'General Talk Forum' started by thebox, Sep 21, 2011.

  1. thebox

    thebox New Member

    Offline
    Messages:
    7
    Trophy Points:
    1
    Location:
    Norway
    Did my first cut with - PHLATPRINTER 3 -
    today :D .... and it looks very good :D .... just had to tighten more on the Allen screws on all axes :oops: Attached files IMG_0531.MOV (36.9 MB)Â
     
  2. 3DMON

    3DMON Moderator Staff Member

    Offline
    Messages:
    2,380
    Trophy Points:
    38
    Location:
    Sebastian, Florida
    I like your choice for a first cut. ;) :dance3:
    I see at the end of the vid the Z axis wasn't coming up like it should. Was this from the set screws coming loose? If not make sure your not missing steps.

    Welcome to the Phlatforum btw. :welcome:
     
  3. thebox

    thebox New Member

    Offline
    Messages:
    7
    Trophy Points:
    1
    Location:
    Norway
    yes it was set screw on the z axis, which came loose .... found new ones.
     

Share This Page