1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

[Fixed] Parameters always zeroed

Discussion in 'SketchUcam Help' started by TigerPilot, Mar 18, 2012.

  1. TigerPilot

    TigerPilot Well-Known Member

    Offline
    Messages:
    1,578
    Trophy Points:
    48
    You can do a few things. First and foremost...get a real computer that runs windows :D :D :tease: :tease:

    You could also look at the constant.rb. At near the bottom is a place to set it. You could also search this forum for exact location. It was mentioned a few times here. I know I did it once.
     
    TigerPilot, Mar 18, 2012
    #1
  2. kram242

    kram242 Administrator Staff Member

    Offline
    Messages:
    6,311
    Trophy Points:
    13
    Location:
    NJ
    kram242, Mar 19, 2012
    #2
  3. TigerPilot

    TigerPilot Well-Known Member

    Offline
    Messages:
    1,578
    Trophy Points:
    48
    What did you do that helped you? Just as FYI to the next person that has the problem.
     
    TigerPilot, Mar 25, 2012
    #3
  4. kram242

    kram242 Administrator Staff Member

    Offline
    Messages:
    6,311
    Trophy Points:
    13
    Location:
    NJ
    Thank you for the update shippo :good:
    Now if anyone has this problem again we can point them here
    Thanks again
    Mark and Trish
     
    kram242, Mar 26, 2012
    #4

Share This Page