1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice

Fold Center line tool bugged in SU8 ?

Discussion in 'Sketchup Help' started by Fred Pena, Sep 19, 2011.

  1. Fred Pena

    Fred Pena New Member

    Offline
    Messages:
    20
    Trophy Points:
    1
    Location:
    Lake County, Ca
    I made the mistake of upgrading to SU8 & now my fold & centerline tool is bugged, no matter what I set the depth for it cuts at 50%. I completely removed SU8 from the puter & reinstalled with the latest Phlatscript to no avail.
    I reinstalled SU7 but am unable to load any files created with ver8, I even had both 7 & 8 open at once & was still unable to copy/paste from 8 to 7.

    Just not sure what to try next any help appreciated-
     
  2. 7up

    7up Moderator Staff Member

    Offline
    Messages:
    1,090
    Trophy Points:
    38
    Location:
    Kentucky
    With your file/model open in SU8, go to FILE > SAVE AS and just below the box where you type in your file name, there is a FILE TYPE drop down selection box. Select SU7 from there and your model will be usable in SU7.

    :good:
     
  3. Fred Pena

    Fred Pena New Member

    Offline
    Messages:
    20
    Trophy Points:
    1
    Location:
    Lake County, Ca
    Thanks Buk!, I never noticed that box before :oops:

    However the problem with the fold & centerline tool persisted even with SU7 & the latest version of Sketchucam, the problem went away when I reverted to version .9231 of the phlatscript, works fine now so I will leave it be-

    Fred
     
  4. 3DMON

    3DMON Moderator Staff Member

    Offline
    Messages:
    2,380
    Trophy Points:
    38
    Location:
    Sebastian, Florida
    After you type the depth be sure to hit the enter key or it will not take.
     

Share This Page