1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

General Purpose Clark Y Balsa Wing

Discussion in 'Single Wing Aircraft Plans' started by Flashsolutions, Jan 24, 2011.

  1. Flashsolutions

    Flashsolutions Active Member

    Offline
    Messages:
    1,123
    Trophy Points:
    38
    Location:
    Leesburg, Florida
    This wing is basically John Bernards design.

    It is the first Balsa project that was successfully cut on my Phlatprinter .

    I changed it a bit to suit my needs since I did not have some of the same sized balsa stock as John.

    We originally did this wing to put on the EO-Cub for a club project, but it would make an excellent general purpose wing.

    The wingspan is approximately 40" with a 7 1/2" chord.

    I used one 6" widths of 1/8 stock x 48" long and one 4" width of 1/16" stock x 36" long.

    The I-Beam construction provides an exceptionally strong wing, yet very very light weight. Attached files Clark Y WING RIBS - ONE SIXTEENTH.skp (590.4 KB)Â Clark Y WING RIBS AILERON - ONE EIGHTH.skp (998.1 KB)Â [​IMG] [​IMG] [​IMG] [​IMG]
     
    Flashsolutions, Jan 24, 2011
    #1

Share This Page