1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

Help setting up Board

Discussion in 'General Driver Card Chat' started by Navop, Sep 6, 2011.

  1. Navop

    Navop New Member

    Offline
    Messages:
    28
    Trophy Points:
    1
    Location:
    St-Telesphore, Quebec, Canada
    Got the usb board from Planet cnc and I want ot setup the following together

    I have the following:

    Stepper motor driver
    http://www.wantmotor.com/ProductsView.asp?id=257&pid=82

    Stepper Motor
    http://www.wantmotor.com/ProductsView.asp?id=160&pid=80

    57BYGH115-003

    Power supply are 2x

    http://www.wantmotor.com/ProductsView.asp?id=266&pid=90
    S-200-24

    Doing a 4 axis hot wire cutter

    Not sure of the setting on the stepper driver, and power supply.
    I did try one motor to one driver with one power supply ... it does run but the revolutions are extremely slow.

    Thanks for allthe help
     
    Navop, Sep 6, 2011
    #1

Share This Page