1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

Motor Speed Control from Mach3

Discussion in 'General Phlatprinter Stuff' started by johnbernard36, Feb 16, 2010.

  1. johnbernard36

    johnbernard36 Member

    Offline
    Messages:
    52
    Trophy Points:
    6
    Location:
    Leesburg, Florida
    I ran into this while looking around for a pwd or freq to AC control schematic to directly control the router from Mach3/g-code.

    There are two variants available, basically one with a case, and a bare board you could build into the machine or controller cabinet.

    http://www.cnc4pc.com/Store/osc/product_info.php?cPath=24&products_id=155&osCsid=a8e58ee81e3d0b4939f7742e9a6502d1 is the one with a case

    and

    http://www.cnc4pc.com/Store/osc/product_info.php?cPath=24&products_id=236&osCsid=a8e58ee81e3d0b4939f7742e9a6502d1 is the bare board

    John
     
    johnbernard36, Feb 16, 2010
    #1
  2. 3DMON

    3DMON Moderator Staff Member

    Offline
    Messages:
    2,380
    Trophy Points:
    38
    Location:
    Sebastian, Florida
    Those look nice. Are you planing to get one? If you do please fill us in on how it works and how you hooked it up.
     
    3DMON, Feb 16, 2010
    #2
  3. johnbernard36

    johnbernard36 Member

    Offline
    Messages:
    52
    Trophy Points:
    6
    Location:
    Leesburg, Florida
    Shaun,

    I'm looking to get one once I finish putting in the tile floor in the garage. Too many projects!

    I see you're in Florida! I'm in Leesburg, are you close to me?

    John
     
    johnbernard36, Feb 16, 2010
    #3
  4. 3DMON

    3DMON Moderator Staff Member

    Offline
    Messages:
    2,380
    Trophy Points:
    38
    Location:
    Sebastian, Florida
    I'm over on the east coast in Sebastian about 2 1/2hrs from ya.
    I hear ya about the too many projects, me too.
     
    3DMON, Feb 16, 2010
    #4

Share This Page