1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

My handy pocket work

Discussion in ''Aircraft KITS' you are working on' started by dhc8guru, May 19, 2011.

  1. dhc8guru

    dhc8guru Member

    Offline
    Messages:
    237
    Trophy Points:
    16
    Location:
    San Antonio
    So, I am doing some redesign my work on my Skywagon. I wanted a deeper electronics compartment so I did a 1/2" deep pocket on the left side half of the fuselage. I also wanted to move the servo's and control rods inboard so that none of it would be seen. So I milled out slots for the control rods to pass thru.
    It was my first attempt at milling out pockets on the PP3. Thought it turned out pretty good. :D

    Attached files [​IMG] [​IMG]
     
    dhc8guru, May 19, 2011
    #1
  2. rcav8r

    rcav8r Moderator Staff Member

    Offline
    Messages:
    1,193
    Trophy Points:
    38
    I thought it turned out VERY good. ;-)

    Is that one pass or multi?
     
    rcav8r, May 19, 2011
    #2
  3. kram242

    kram242 Administrator Staff Member

    Offline
    Messages:
    6,311
    Trophy Points:
    13
    Location:
    NJ
    Nice job! :doubleup:
    Mark and Trish
     
    kram242, May 20, 2011
    #3
  4. dhc8guru

    dhc8guru Member

    Offline
    Messages:
    237
    Trophy Points:
    16
    Location:
    San Antonio
     
    dhc8guru, May 20, 2011
    #4

Share This Page