1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice

Open door error code

Discussion in 'SketchUcam Help' started by Richard Watson, Feb 26, 2017.

  1. Richard Watson

    Richard Watson New Member

    Offline
    Messages:
    6
    Trophy Points:
    1
    Location:
    UK
    Hi
    I am a Noob at this ,I have built a c-machine all went well with the tests ,my first project cut was a simple circle
    it made the cut ok but during the step cuts at the same point the program stopped with the error code ( open door ) after clicking resume it jumped a point about 1/8th and kept repeating this at the same point . I dont have a door and allways makes this stop without any interaction from me.
    thanks for your time.
    Richard
     
  2. swarfer

    swarfer Moderator Staff Member

    Offline
    Messages:
    808
    Trophy Points:
    28
    Location:
    Grahamstown, South Africa
    Please post your gcode file.

    Also, check that nothing is connected to pin A1 on the Arduino.
    If there is nothing and there is no wiring near it, then connect it to 5v with a 2000 ohm resistor to make it does not pick up electrical interference.
     

Share This Page