1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

PCB engraving

Discussion in 'Projects on your Phlatprinter 3' started by TigerPilot, Aug 29, 2011.

  1. TigerPilot

    TigerPilot Well-Known Member

    Offline
    Messages:
    1,578
    Trophy Points:
    48
    I know some had made PCB on the PP . What did you use as a carrier? I tried to cut a PCB and somehow the piece is not level. I used dollar tree foam. It was just cutting at right, deep cutting in the middle and not cutting at all on the left.
     
    TigerPilot, Aug 29, 2011
    #1
  2. Kroko

    Kroko Member

    Offline
    Messages:
    106
    Trophy Points:
    16
    This is common problem on all routers.
    One solution is to mill flat bed for your PCB first - Phlatbed :D
     
    Kroko, Aug 29, 2011
    #2
  3. TigerPilot

    TigerPilot Well-Known Member

    Offline
    Messages:
    1,578
    Trophy Points:
    48
    I didn't know that. Thanks Kroko. :good:
     
    TigerPilot, Aug 29, 2011
    #3
  4. Kroko

    Kroko Member

    Offline
    Messages:
    106
    Trophy Points:
    16
    New software version now supports import of Gerber files.
    Now you can mill PCBs directly from Gerber files.
     
    Kroko, Aug 31, 2011
    #4
  5. kram242

    kram242 Administrator Staff Member

    Offline
    Messages:
    6,311
    Trophy Points:
    13
    Location:
    NJ
    This is fantastic Kroko! :doubleup:
    Thank you!!!
    Mark and Trish
     
    kram242, Aug 31, 2011
    #5

Share This Page