1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice

pk266-01A settings

Discussion in 'Trouble Shooting - Support - Help Section' started by Navop, Aug 25, 2009.

  1. Navop

    Navop New Member

    Offline
    Messages:
    28
    Trophy Points:
    1
    Location:
    St-Telesphore, Quebec, Canada
    What would be a good setting for these motor pk266-01A

    Like what can I set the V-REF and PFD ?
    In mach3 what can I set the motor tuning ? (step)(velocity)(acceleration)

    I don't need the exact but it would be great a idea.

    will eventually change the other 2 motors to pk266-01A

    for now I'm just playing with the y axis....

    thanks for all info
     
  2. frankrcfc

    frankrcfc New Member

    Offline
    Messages:
    381
    Trophy Points:
    0
    Location:
    Battle Creek, Mi
    My X is 1025.641026 55.002 18
    Y is 31863.22987 55.002 12
    Z is 34285.71429 25.002 11

    Mark recommends initially
    X 1000 20 20
    Y 13953.48837
    Z 30000 20 20
     
  3. Anonymous

    Anonymous New Member

    Offline
    Messages:
    1,280
    Trophy Points:
    0
    Navop, the spec sheet I found says those motors have 0.71 Amps/phase [Bipolar (Series) mode] so I believe that means your V-REF max should be 1.42 V. (Twice the Amps/phase number)

    I don't think I've ever seen an equation for setting the PFD, it's just tuned until the stepper runs the smoothest at your typical running / cutting speed.
     

Share This Page