1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

React Bipe not yet test flown by request, by AnyAirRc

Discussion in 'Double Wing Aircraft Plans' started by mrbubbs, Nov 20, 2009.

  1. mrbubbs

    mrbubbs New Member

    Offline
    Messages:
    50
    Trophy Points:
    0
    Location:
    Kalamazoo, Michigan, US
    React Bipe not yet test flown by request
    Post by AnyAirRc » Tue Oct 14, 2008 10:05 pm

    Here is my Reactor Bipe clone 26" wing span for 1/8th" thick foam 20"x30" (I use ReadIBoard). Make sure you home the printer with the bit just fully under the right side of the foam and dang near touching the foam. I have yet to test fly this but I am sure it will kick but! Attached files react.zip (30.6 KB)Â react_4mm_gcode.zip (75.5 KB)Â
     
    mrbubbs, Nov 20, 2009
    #1
  2. mrbubbs

    mrbubbs New Member

    Offline
    Messages:
    50
    Trophy Points:
    0
    Location:
    Kalamazoo, Michigan, US
    Re: React Bipe not yet test flown by request
    Post by 7up » Fri Oct 17, 2008 10:50 am

    Here is anyairrc's Reactor Bipe worked up for 6mm/1/4" foam. Hope it works OK.

    Nice job anyair

    I left the original 20"x30" layout, move the pieces if you like just remember to select the entire piece that you wanna move by triple clicking it. Attached files Reactor Bipe anyair.zip (58.6 KB)Â
     
    mrbubbs, Nov 20, 2009
    #2

Share This Page