1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice

Up and running

Discussion in 'MOTORS - Stepper Motors' started by frankrcfc, Jan 11, 2009.

  1. frankrcfc

    frankrcfc New Member

    Offline
    Messages:
    381
    Trophy Points:
    0
    Location:
    Battle Creek, Mi
    Alright. Brian came over earlier today and proceeded to put my printer on the straight and narrow. installed the new chip on the Y tested and tuned up the steppers. Now running consistently at 40 on the x. 40 on the Y and 8 on the Z. I could take it way on up with ease but I am very happy with those down the middle speeds. Also running the dremel at half speed no problem. I've done no mods at all except the steppers of course and making room for the Y stepper. Everything runs at room air temperature. :p
    www.anaheimautomation.com for the Y motor. 23Y206S-LW8
    www.circuitspecialists.com for the X and Z motor. NEMA 23 (57BYGH207)
    www.arrow.com for my ic chip A3977SED-T
     

Share This Page