1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice

Y Axis Belt Tension

Discussion in 'Troubleshooting and Build Support' started by samr&d@IntroSpec, Dec 22, 2013.

  1. samr&d@IntroSpec

    samr&d@IntroSpec New Member

    Offline
    Messages:
    7
    Trophy Points:
    1
    Location:
    Hammond, IN
    Hello!

    This maybe a simple problem but I am trying to tension they Y axis up after the machine has been left idol for over a year. Long story, but I only have access through the door to 3 of 4 bolts. Besides taking the whole side off am I missing something?

    If I have to take the side off so be it but would really like to avoid that if possible.

    Anyone have any maintenance tips/schedules etc..
     

    Attached Files:

  2. TigerPilot

    TigerPilot Well-Known Member

    Offline
    Messages:
    1,578
    Trophy Points:
    48
    I took the side panel off when I had to do it. It was not a big deal. Not so many screws. I shimmed the printer so that the side I was taking off was up a bit. Made it easier to remove the panel.
     
  3. samr&d@IntroSpec

    samr&d@IntroSpec New Member

    Offline
    Messages:
    7
    Trophy Points:
    1
    Location:
    Hammond, IN
    Thank you! I have the machine on a stand that I can slide that edge off and should be able to get that panel off.

    Hope you have a great holiday!

    Cheers,
    Steven
     

Share This Page