1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

Change cutter diameter requires restart

Discussion in 'SketchUcam Bugs' started by generalsocial, Dec 25, 2014.

  1. generalsocial

    generalsocial New Member

    Offline
    Messages:
    23
    Trophy Points:
    3
    If I have a 1/16" cutter in the settings I can hover around and see the lines of a inside or outside tool path when I touch an object.

    I then change the cutter to 1/32 or 1/2 or something. The lines remain the same. I don't get a different path unless I restart sketchup and reload the file...

    Is this a but or is it by design?
     
    generalsocial, Dec 25, 2014
    #1
  2. swarfer

    swarfer Moderator Staff Member

    Offline
    Messages:
    808
    Trophy Points:
    28
    Location:
    Grahamstown, South Africa
    you don't need to restart, but you do need to reselect the cut tool so that it picks up the new diameter.
     
    swarfer, Dec 26, 2014
    #2

Share This Page