1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

ET's Birthday Fly-In

Discussion in 'Fun Fly's' started by kram242, Jan 21, 2011.

  1. kram242

    kram242 Administrator Staff Member

    Offline
    Messages:
    6,311
    Trophy Points:
    13
    Location:
    NJ
    Hey guyz,
    Here is a short video of EvilTunez Birthday Fly-In where we test out the flying wing :)
    Although the wing needs work we had a great time! Its always fun to break away like this and just go fly :D
    Happy Birthday Glen!
    Mark and Trish
     
    kram242, Jan 21, 2011
    #1
  2. theothers

    theothers Administrator Staff Member

    Offline
    Messages:
    761
    Trophy Points:
    18
    Location:
    New Jersey
    Great job on the video Mark. That was a lot of fun! Looks like it's back to the drawing board for the flying wing.
     
    theothers, Jan 21, 2011
    #2
  3. kram242

    kram242 Administrator Staff Member

    Offline
    Messages:
    6,311
    Trophy Points:
    13
    Location:
    NJ
    Thanks kid ;)
    That was a lot of fun! I only wish that the wing flew great right out of the gate :)
     
    kram242, Jan 21, 2011
    #3
  4. mudman1959

    mudman1959 Member

    Offline
    Messages:
    94
    Trophy Points:
    8
    Wish I had some of the micro gear, I'd get Nav (Tim) to cut one and I would get it flying... :roll: You need to look at this link and recalculate your cg... It's needs to glide with power off before it can soar with power on... :ugeek: Mudman1959

    http://fwcg.3dzone.dk/?wing_span=48&roo ... ac_lines=0
     
    mudman1959, Jan 21, 2011
    #4

Share This Page