1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

Orbit tool

Discussion in 'Sketchup Help' started by Navop, Jun 20, 2009.

  1. Navop

    Navop New Member

    Offline
    Messages:
    28
    Trophy Points:
    1
    Location:
    St-Telesphore, Quebec, Canada
    K used the orbit tool to move drawing arond, but now I can't seem to put it back in the correct angle.

    Meaning when looking at the picture its all out of angle. its a little to flat out.

    Is theire a way to reset the picture so its parallel to the green line and red line

    If you need pix to understand my delima I'll post them.

    Thanks
     
    Navop, Jun 20, 2009
    #1
  2. kyyu

    kyyu Active Member

    Offline
    Messages:
    1,183
    Trophy Points:
    36
    Location:
    Maryland
    Use the "view" toolbar, to get the standard views like top, front, right and left. Go to "View > Toolbars > View " to activate the toolbar.

    -Kwok
     
    kyyu, Jun 20, 2009
    #2
  3. Navop

    Navop New Member

    Offline
    Messages:
    28
    Trophy Points:
    1
    Location:
    St-Telesphore, Quebec, Canada
    TY :D
     
    Navop, Jun 20, 2009
    #3

Share This Page