1. Hey guyz. Welcome to the All New Phlatforum!



    Sign Up and take a look around. There are so many awesome new features.

    The Phlatforum is a place we can all hang out and

    have fun sharing our RC adventures!

  2. Dismiss Notice
Welcome to The Phlatforum PhlatPrinter III

SlowBipe's Phlatprinter Build #12.

Discussion in 'General Phlatprinter 3 Chat' started by SlowBipe, Dec 5, 2010.

Page 2 of 2
  1. iflyos

    iflyos Member

    Offline
    Messages:
    306
    Trophy Points:
    16
    Location:
    Pfafftown, NC
    Good deal!! Let us know what you find out!
     
    iflyos, Jan 10, 2011
    #26
  2. SlowBipe

    SlowBipe Member

    Offline
    Messages:
    62
    Trophy Points:
    6
    Well, I took a look at the EasyCNC board last night and decided that removing one of the chips from the socket is not something I want to attempt without some direction. I think I'll wait to hear back from Mark on what to do next.

    I have a couple of emails into him. I know he is real busy.

    SlowBipe
     
    SlowBipe, Jan 11, 2011
    #27
  3. kram242

    kram242 Administrator Staff Member

    Offline
    Messages:
    6,311
    Trophy Points:
    13
    Location:
    NJ
    Hi SlowBipe, sorry to hear that your having these problems we have your emails and will respond as soon as I figure out what else it may be, just wanted to let you know we are here :)
    Thanks
    p.s. the chips on these new boards are really hard to change out now as they have been socketed very tight so without a chip puller its next to impossible.
    Mark and Trish
     
    kram242, Jan 11, 2011
    #28
Page 2 of 2

Share This Page